|
|
|
#1
01-15-2016, 08:03 PM
|
|||
|
|||
New member from Oregon
Hi everyone,
I ran across this forum while searching for information on sheetmetal work and metal shaping. I'm really interested in learning more! My primary interests are in the automotive side of things, but I'm also interested in art and general metal shaping practices. Looking forward to checking out the forums! Thanks!
__________________
Marcus 
|
|
#2
01-16-2016, 05:03 PM
|
|||
|
|||
|
Hi Marcus welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
01-18-2016, 05:51 PM
|
||||
|
||||
|
Hello Marcus and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
