|
|
|
#1
01-16-2016, 11:25 AM
|
|||
|
|||
New member from Washington State
Hello folks,
I have some automotive projects that I'm planning to make repair panels for and after finding this forum it appears that I have a wonderful resource at my disposal. Thank You. Abe
__________________
Abe 
|
|
#2
01-16-2016, 05:05 PM
|
|||
|
|||
|
Hi Abe welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
01-18-2016, 05:45 PM
|
||||
|
||||
|
Hello Abe and welcome to the site.
When you have a question try to add some pictures. It really helps with getting you the correct answer. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
