|
|
|
#1
01-30-2016, 09:18 PM
|
|||
|
|||
introduction for john bordelon
before I studied mechanical engineering at virginia military institute I went to lincoln tech trade school for automotive mechanics. I love working on/fixing things and recently got into wire feed welding. All that was missing in the tool box at that point was basic metal shaping skills and I have been trying that to add to my "very" basic bondo and paint skill set. You guys seem like the guys to learn from as far as I'm concerned.
regards john
__________________
john k bordelon 
|
|
#2
01-31-2016, 10:06 PM
|
||||
|
||||
|
Hello John and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
02-01-2016, 08:00 AM
|
|||
|
|||
|
Hi John welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
