|
|
|
#1
02-16-2016, 01:58 PM
|
|||
|
|||
Introduction
Hello from Phoenix.
My name is Chris and I've played with cars, trucks, motorcycles, etc. since I was a little kid. I've always had a couple of project vehicles around. I have the mechanical/electrical part down but never played much with body repair and or mods. Now that I'm retired I'm looking forward to learning some new things. Thanks Chris
__________________
Chris 
|
|
#2
02-16-2016, 04:48 PM
|
||||
|
||||
|
Hello Chris and welcome to the site.
You are at the place for learning new things.  Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
02-16-2016, 06:00 PM
|
|||
|
|||
|
Hi Chris welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
