|
|
|
#1
04-26-2016, 10:40 AM
|
|||
|
|||
New guy from Texas
Hello all,
My name is Josh... and I am interested in learning about metalshaping. I'm getting ready to start repairing rust on my 58 Chevy Apache, and I'd like to make the panels myself. I'm a die-hard gearhead, and have some limited fabrication experience, but sheetmetal in particular is new to me. So I'm here to try and learn!
__________________
Josh Lowrey 
|
|
#2
04-26-2016, 11:12 AM
|
|||
|
|||
|
Hi Josh welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
05-12-2016, 11:20 AM
|
||||
|
||||
|
Hello Josh and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
