|
|
|
#1
02-01-2011, 06:45 PM
|
|||
|
|||
Hi All
Hi all, looking forward to participating on this forum. I will probably be reading more than posting, at least for a while. I'm a pretty good all-round fabricator but I am not at the level of you all making fenders and things out of sheet metal. I have a good home shop with all of the basics plus some, but no English wheel, planishing hammer or the like. Then again I guess you can do a lot with a hammer and anvil. Anyway, nice to be here are from the little I have seen there are some really interesting projects under way. Like that Opel Kadette - I used one as my gas crisis car back in the 70s. Hard to believe they did not all rust away, but I guess that that is what this forum is about.
__________________
John 
|
|
#3
02-01-2011, 07:59 PM
|
||||
|
||||
|
John, welcome to the site. Thanks for the introduction, looking forward to you showing us some of your projects. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Linear Mode
