|
|
|
#1
06-04-2011, 07:26 PM
|
|||
|
|||
Hello from Centerville, Ohio
I have been lurking and have finally gotten myself in a position to start shaping some metal. My experience is limited to basic automotive sheetmetal replacement. Looking forward to learning as much as possible from the site.
I'm currently purchasing some equipment for my shop and have a wish list for future purchases. Thanks, Berzerk
__________________
Bill Ziegert Centerville, Ohio 
|
|
#2
06-04-2011, 08:27 PM
|
||||
|
||||
|
Welcome fellow buckeye, lots to learn here & lots of great people
|
|
#3
06-04-2011, 09:54 PM
|
||||
|
||||
|
Bill, welcome and thanks for the introduction. There is a lot of information here to get you started and help you learn metal shaping. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
06-06-2011, 09:58 PM
|
||||
|
||||
|
Welcome! To Allmetalshaping!
__________________
Jacob Hunsinger Shrinking using a stump: https://www.youtube.com/watch?v=-HAFndATFo4&t=7s Making a reverse using a stump: https://www.youtube.com/watch?v=7PlF1BoMCQI Circular Truss E-Wheel http://allmetalshaping.com/showthread.php?t=15419
|
 |
|
|
Linear Mode
