|
|
|
#1
09-25-2011, 05:35 PM
|
|||
|
|||
Hi from Ohio
Hi everyone
I have been watching these sites for a few years now and I always find some new project that makes my jaw drop. I'm am as amazed today as I was the first time I stumbled upon metal working forums with how generous you all are with your talent and knowledge by sharing and helping anyone who asks. I hope to continue to learn and be amazed by the projects that are shared here and one day be able to pass that knowledge onto some other enthusiast. I am currently working on two 1937 Packard’s and the latest one is going to push me way past my experience level but I am definitely looking forward to it. I am currently looking at Steve Hamilton’s post on the rear Packard fender, it’s very inspiring. Keep the hammers flying! Johnny Barnes
__________________
Johnny If I can't figure it out...I'll get a bigger hammer 
|
|
#2
09-25-2011, 06:18 PM
|
||||
|
||||
|
Johnny, welcome and thanks for the introduction. Hope you enjoy the site and that it helps you with your projects. Thanks for joining us. If you questions, ask and someone will try to help you.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
09-25-2011, 06:47 PM
|
||||
|
||||
|
Welcome aboard fellow buckeye
|
|
#5
09-25-2011, 07:37 PM
|
|||
|
|||
|
Welcome to the site Johnny
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#6
09-26-2011, 03:50 PM
|
|||
|
|||
|
Welcome to the site Johnny
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#7
09-26-2011, 05:36 PM
|
|||
|
|||
|
Thanks everyone for welcoming me into your group. David I couldn't put it off any longer I ordered your DVD this morning and looking forward to its arrival.
__________________
Johnny If I can't figure it out...I'll get a bigger hammer
|
|
#8
09-26-2011, 06:54 PM
|
||||
|
||||
|
Welcome Johnny!
__________________
Jacob Hunsinger Shrinking using a stump: https://www.youtube.com/watch?v=-HAFndATFo4&t=7s Making a reverse using a stump: https://www.youtube.com/watch?v=7PlF1BoMCQI Circular Truss E-Wheel http://allmetalshaping.com/showthread.php?t=15419
|
 |
|
|
Linear Mode
