newb to this site and to metal shaping

[sandcar]

Hello everyone,

I am new to this site and to the art of metal shaping. I have experience with metal fab but no sheet work. This has been ok for the sand rails with flat body panels but I want to start shaping the panels and doing full bodies some day.
I have thought about taking some courses from lazze but not sure if it is possible time wise. Are there any shaping shows or expos coming up in the Salt Lake City to Denver to Las Vegas areas? I would love to participate.
I look forward to learning from each of those who post projects and threads and will draw inspiration from following your projects.

[Joe Hartson]

Ryan, welcome and thanks for the introduction. Hope you enjoy the site and find if helpful. Thanks for joining us.