|
|
|
#1
12-28-2011, 11:14 AM
|
|||
|
|||
neilswheels
Another newbie! I found this site via the H.A.M.B. and thought I could learn a lot to help me out with my car stuff, and maybe at work, as I am a blacksmith/fabricator, tho most of my stuff at work tends to be bar stock, no sheet.
I hope I can contribute as well, tho from what I've seen so far, most of you have way more sheet metal skills than me. Neil
__________________
Neil 
|
|
#3
12-28-2011, 03:34 PM
|
||||
|
||||
|
Neil, welcome and thanks for the introduction. Hope the site help you improve you skills. If you have any questions just ask and someone will try to help you. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
12-28-2011, 10:25 PM
|
|||
|
|||
|
Welcome to the site Neil
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
