|
|
|
#1
01-31-2012, 06:39 PM
|
|||
|
|||
New Guy - middle aged kid from Muskoka Ontario
Hi All,
I'm Doug from Muskoka Ontario, a semi retired coffee roaster with aspirations of actually starting - then finishing up - the three (3) 1939 Chev trucks I have accumulated in the last 10 years. These are not the pristine barn finds one sees in Rod & Custom, more the bent up, salt rusted hulks one finds in the fields and junk yards of Ontario. I'll be needing help and guidance to hammer out at least 6 fenders (front) and 4 fenders (back). I'm going to cheat and put a stakebed on one - cause I can do a mean bit of woodwork if really pressed. Looking forward to being a part of this forum . . . should be fun!
__________________
Doug (when I grow up I'd like to be a kid again) 
|
|
#2
01-31-2012, 07:21 PM
|
||||
|
||||
|
Doug, welcome and thanks for introduction. Hope you enjoy the site and find it helpful. Sound like you have an interesting project that will keep you busy for a while. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
01-31-2012, 10:23 PM
|
|||
|
|||
|
Hi Doug! Welcome to All Metal Shaping
__________________
Nick M. Some more projects: http://www.facebook.com/iNVisionPrototypes https://www.instagram.com/invisionprototypes https://www.youtube.com/c/iNVisionPrototypes
|
|
#5
02-01-2012, 02:11 AM
|
|||
|
|||
|
Welcome to the site Doug
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
