|
|
|
#1
07-12-2012, 09:22 PM
|
|||
|
|||
Prospective member from Oakdale, CA.
I'm Curt from Oakdale. I'm far from new to running a Lathe/Mill/Welding, but sheet metal is pretty new to me. I'm just about done building my English Wheel. Hope this get's me in! Thanks.
Curt 
|
|
#3
07-13-2012, 01:44 AM
|
||||
|
||||
|
Curt, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
07-13-2012, 06:16 AM
|
|||
|
|||
|
HI and welcome to the forum Curt
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
