Getting into sheetmetal

[magnareo]

been in to metal for the last couple years through going to college and working with welders in the oil field.

I went to school to be a machinist currently an apprentice and work in the field, done lots of welding in the shop along with hobby work

Bought a bike that blew up and needed to retro fit a new motor to fit the old bike while i was at it chopped it up a little got my interest in metal work. Bought two more bikes this summer and want do some neat sheet metal work that will make it different.

I built a planishing hammer framed but need dies can anyone help me out I'm located in Manitoba, Canada.

I'd also like to find English wheel dies, only have to be good enough for a beginner,

[HEATNBEAT]

Hi Brendan and welcome!

[Peter Tommasini]

HI Brendan welcome to the forum
Peter

[David Gardiner]

Hi Brendon, welcome to the site.

David