|
|
|
#1
10-09-2013, 07:55 AM
|
|||
|
|||
hello
Hello
I am located in central Iowa. I am trying to advance my metalworking abilities and found this site. I work in the aviation industry and have basic metalworking abilities. I am currently trying to improve my Mig and Tig welding skill level. I can do ok with Mig but am just starting out with Tig. Everything I weld is under 1/4", mostly thin gauge sheetmetal. Hope to learn here. Gary 
|
|
#2
10-09-2013, 01:15 PM
|
||||
|
||||
|
Hello Gary and welcome. You will find lots of helpful advise on this sight.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
10-09-2013, 05:25 PM
|
|||
|
|||
|
Hi Gary welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
