|
|
|
|
|
#1
04-12-2015, 12:22 AM
|
|||
|
|||
North AL introduction
Hidiy everyone- I'm redacting my long-winded introduction statement...
I'm really enjoying the site & can already tell I have a LOT to learn. I hope to find a gathering or something to learn a bit of shaping 'hands-on'---- the tutorials are a great help, but I can tell I really need to learn the basics. I'm a quick learner and the current project is a 1955 Chevy truck rear fender panel. Then there's a John Deere lawnmower hood I have in mind to make. Just anything that I actually need that I can learn a good variety of shaping skills with. I'm working on making some tuck pliers tonight, so we'll see how that goes. (edited 4-14)
__________________
Brad Last edited by Uncle Brad; 04-14-2015 at 09:56 AM. Reason: long winded & irrelevant 
|
|
#2
04-12-2015, 08:00 AM
|
|||
|
|||
|
Wow- I was tired & long-winded too on the intro...
Is there a set amount of time after inactivity that you are automatically logged off? Or is this just a new member feature? Thanks Brad
__________________
Brad
|
|
#4
04-12-2015, 09:36 AM
|
||||
|
||||
|
Welcome to AllMetalShaping Brad.
__________________
Kerry Pinkerton
|
|
#5
04-12-2015, 09:15 PM
|
|||
|
|||
|
Hi Brad welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Hybrid Mode
