|
|
|
|
|
#1
01-15-2016, 11:26 AM
|
|||
|
|||
Hello from Minnesota
Hello All -
I was doing some research on metal shaping for an old truck restoration and thankfully, I found this forum. I don't have much experience in metal shaping, but have always been amazed at the work some folks can accomplish with some pretty basic tools and lots of hours of practice. I've got a decent sized workshop, mostly woodworking, and I'm planning to dedicate some of the floor space to metal forming. Looking forward to getting to know some of you and would love to touch base with any Minnesota members who might be willing to offer advice on local resources. Thanks and regards, Corey Puchalski Chaska MN 
|
|
#2
01-19-2016, 09:20 PM
|
|||
|
|||
|
Welcome Corey! Keep an eye out for an event in that section, otherwise you would be surprised at the MN members who will invite you to their shops to show you a few things.
__________________
Christopher Rathman Chris' Autobody Restoration Service
|
|
#3
01-20-2016, 12:49 PM
|
||||
|
||||
|
Hello Corey and welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#4
01-20-2016, 04:32 PM
|
|||
|
|||
|
Hi Corey welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Hybrid Mode
