|
|
|
|
|
#1
04-18-2013, 09:44 PM
|
|||
|
|||
New Guy from Oregon
This is Cal from Cottage Grove, OR. I am retired from the Navy and am now indulging hobbies which have been off the boil for 20 years.
Lane Community College is trying their best to teach me something about collision repair and paint; the (far) better half has picked up an 1940 Chevrolet Sedan Delivery to frustrate me. I joined this board to read about various sheet metal techniques and have a place to go when the metal isn't doing what I want it to.
__________________
Cal Swanson Student Retiree Squid 
|
|
#3
04-19-2013, 01:40 AM
|
|||
|
|||
|
HI Cal welcome to the forum
You can make metal doing what you whanted to do....it's just take practice and lot's of mistakes...... be patient! Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM Last edited by Peter Tommasini; 04-19-2013 at 01:45 AM.
|
 |
|
|
Hybrid Mode
