|
|
|
|
|
#1
07-10-2013, 03:34 PM
|
|||
|
|||
New from Sweden.
Hi, im Tomas from sweden, live close to Uppsala. Been a Sheet Metalworker/Welder for about 30 years ( im 51 ) Un employed at the moment, since i lost my job as an sheetmetal worker at the Airlines, after + 25 years there. Planning now to start my own shop, working on Cars and Bikes(older ones) (sheetmetalwork and paint). Have a 100 square meter garage, that i now is working on( prepairing) have a lot of equipment, so im almost prepaired to start. Looking forward to get and to share, things here on the forum. Hopefully i hope you all understand my writing. Regards. Tomas.....
__________________
Tomas W. 
|
|
#2
07-10-2013, 03:42 PM
|
|||
|
|||
|
Welcome Thomas!
Uppsala is not far from my Place in Avesta! Looking forward to see your work and I will wish you a good luck with your Company!
|
|
#3
07-10-2013, 03:42 PM
|
||||
|
||||
|
Welcome Thomas
Ussually things happen for a reason..... now you will have the freedom to work on what you enjoy. Good luck in your new venture. Steve
__________________
Steve Hamilton Hamilton Classics Auto Restoration & Metalshaping
|
|
#4
07-10-2013, 04:14 PM
|
|||
|
|||
|
Welcome aboard, Tomas
 All the best in your new venture too!
|
|
#6
07-11-2013, 05:55 AM
|
|||
|
|||
|
HI Tomas welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#7
07-11-2013, 09:36 AM
|
|||
|
|||
|
Hello Tomas - welcome to the forum. I hope it all works out for you.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Hybrid Mode
