|
|
|
#1
01-15-2012, 05:35 PM
|
|||
|
|||
Hello from Fresno
My name is Steve Sargent and I'm from Fresno, CA. Three years ago, I found a 72 MG Midget roller. I'd been looking for a automotive project so my two sons could get a little education on car basics. One thing led to another, so after an engine and suspension swap, I need to start replacing the sheet metal we've removed. My metal working skills are limited so I thought I'd join here to learn how to use the equipment I've been buying.
__________________
Steve Sargent 
|
|
#2
01-15-2012, 10:00 PM
|
||||
|
||||
|
Steve, welcome and thanks for the introduction. Hope the site will be helpful with your project. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
01-16-2012, 01:53 AM
|
|||
|
|||
|
Welcome to the site Steve
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
