|
|
|
#1
10-31-2012, 09:31 PM
|
|||
|
|||
Hi from VA
Hi there,
I read a few of the intros and it looks like most of you are far more experienced than me, but I'm here to learn. I have a small (just me) powder coating and metal fabrication shop. I do a lot of cnc plasma cutting for signs and off road parts. I am currently restoring a 50 GMC truck that has been occupying my driveway for a few years. This is more precise hammer and dolly work than I usually do, but I really enjoy it. I also make knives. You can check the knives out on my facebook page: http://www.facebook.com/pages/Drylab...58582367526515 If that link doesn't work you can search "Drylab Fabrication" on facebook.
__________________
-Aaron Brandes Drylab Fabrication 
|
|
#2
10-31-2012, 09:58 PM
|
||||
|
||||
|
Aaron, welcome and thanks for the introduction. Hope you enjoy the site and find it useful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
10-31-2012, 10:19 PM
|
|||
|
|||
|
HI Aaron welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
10-31-2012, 11:38 PM
|
||||
|
||||
|
Hello Aaron,
I get into your neighborhood every once in a while.. When riding my motorcycle.... also, Captain Kirk isn't too far from you in Warrenton... I guess you are a member of NVKCC.. I used to be a member a long time ago... Welcome aboard....
__________________
Bill People will do things that nobody else will......
|
|
#6
11-01-2012, 02:21 AM
|
|||
|
|||
|
Aaron, welcome to allmetalshaping, you obviously have hand skills so its a case of learning techniques and then practicing.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
