Richard Lennard Introduction

[Richard Lennard]

I have nearly completed my workshop, 11.5m x 8m.
Over the years I have been following the various Metalwork forums and have been collecting my equipment accordingly.
I have done little practical work, compared to many on this site, but am desperate to learn, have good hands and the time to do it.
Ive been lucky to have built up the following:
Pullmax Major, with a fair bit of tooling, Edwards English wheel, swager, folder, guillotine, Migs, Tig, Chinese English wheel (not so good), planishing hammer (good), rolls / bender / guillotine combo, compressors, oxy / ace, Myford lathe, Holbrooke lathe, linisher, bandsaw + large amount of panel beating hammers / dollies / stakes etc.
To be honest - spoilt.
It all started about with a rebuild for my Sunbeam Tiger, which didnt happen in 1978. Sold the Tiger, bought it back again in 2000, definitely needs a rebuild now!
Cant wait!
I intend to refurb all the metalwork gear as I install it.
richard_lennard1@yahoo.co.uk