Hey everybody Chris here with an Intro

[outlawfabrication]

Hi ALL,

My name is chris and found this fourum as i was searching for some e-wheel anvils (as currently i haven't access to a lathe) and read a few threads that were packed with alot of good info, anyways here i am!
A little about myself i have always been of the fabricating type mainly because growing up if i wanted something i couldn't afford i figured out how to build it. That led me into the Automotive industry starting out in a dealership and and working up to the world of motorsports (rally racing) where it was there that i shifted some attention back to sheet metal crafting instead of the more structural work like building roll cages, sub-frames, body modifications and chassis work that i was immersed in. I had taken a metallurgy course offered by fay butler and it was at that course the proverbial light switched was flipped and i had to learn and attempt to improve more in the relm of metal shaping. Currently i'm in the beginning stages of building an E-wheel and have been looking over the different design and construction options. I look foward to indulging into the vast amount of knowledge in this forum and it's participants, while helping anywhere i can.

regards
Chris...you can now wake up : )