All MetalShaping

Go Back   All MetalShaping > GETTING STARTED > Introductions
Register All Albums Event Calendar Today's Posts Search
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 02-08-2010, 07:47 PM
todd_a's Avatar
todd_a todd_a is offline
Member
 
Join Date: Jun 2009
Location: Tyler - East Texas
Posts: 29
Default Been here a while but not introduced - Texas

Hey I joined last summer and I have just never posted anything until today and then I realized I never posted an introduction, so I figured I better get to it.

I'm Todd from East Texas - about 90 miles east of Dallas. I am currently building a 1931 Model A Coupe. It was someone else's project that didn't get too far after they tore it all apart and installed an engine, tranny, rear end and suspension on the frame. A lot if it was half-assed, so there was a lot of re-do work that had to be done. I had to cut the rear section of frame out and make that all new from scratch and for the body there was nothing but the shell and no floor at all. The top was chopped but the doors were not done and it was missing tons of stuff. I've tried to use as much of the parts that were included because I paid more than I should have for it, but it is starting to come together a little now. Lots of work left to do!

Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:31 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.