New member from New Zealand

[skintkarter]

Hi Stuart. Welcome! I'm just down the road from you in a paddock in Manurewa. View is not as good I don't know much about shaping either, but there are lots of very clever people on here who are very giving of their time and knowledge. I'm also lucky to have two local metalshaping mates who are gods of this stuff and both inspire and mentor me. What projects do you have?

[Peter Tommasini]

Hi Stuart welcome to the forum
Peter

[saj]

Originally Posted by skintkarter

Hi Stuart. Welcome! I'm just down the road from you in a paddock in Manurewa. View is not as good I don't know much about shaping either, but there are lots of very clever people on here who are very giving of their time and knowledge. I'm also lucky to have two local metalshaping mates who are gods of this stuff and both inspire and mentor me. What projects do you have?

HI Skintkarter. Nice to hear from you. Currently I am working on two model A Ford's. I have to reform the damaged mudguard on one and repair rust in the rear of the other. Plus a couple of machine guards to make for my factory.

[Jere]

Hello Stuart and welcome.

Jere

[philrally]

Hi Stuart,
Good to hear from you. I'm in Ngatea- pretty close to you. I know all about your products. Turbo bog and Newtech we used about 20 years ago when i was an apprentice panelbeater.
I'm useless at stick welding unless its full contact and i have two eyes! Not very good for sheet metal anyway i reckon.
Bring on the Model A!
Phillip Broadbent www.ngateapanelbeaters.co.nz

[saj]

Originally Posted by philrally

Hi Stuart,
Good to hear from you. I'm in Ngatea- pretty close to you. I know all about your products. Turbo bog and Newtech we used about 20 years ago when i was an apprentice panelbeater.
I'm useless at stick welding unless its full contact and i have two eyes! Not very good for sheet metal anyway i reckon.
Bring on the Model A!
Phillip Broadbent www.ngateapanelbeaters.co.nz

HI Philraly. Nice to hear from you. I know Ngatea Panel beaters. Good website too. I started with Bond o fil way back in the.the 60's at Stewart Foot and Co. We made Rocol lubricants, GUD filters, Duplicolor, Turtle wax, Redex and all sorts of well-known products that are gone from NZ now. My main products now are Builders Bog, Turbo, Newtech, and polyester resins for fibreglass. Shows my age eh?
But I have time to extend my panel working skills now I am older and this is what I really enjoy.