|
|
|
#1
03-16-2011, 08:47 AM
|
||||
|
||||
Hello from mid Michigan
I am a retired manufacturing engineer from the automotive sector. Specifically I was responsible for the final assembly and testing equipment associated with building Halfshafts worldwide for GM/Delphi.
This included the process concept, cost estimating, purchase specing, quoting, desigining and errorproofing, building, runoff, installation, and qualification in countries like Germany, Italy, China, Mexico, Brazil and of course the US. My web site shows our passion for travel to all 7 continents, flying RC aircraft planes and helis, and Scuba. At home I relax with metal fabrication and welding of structural steel, SS, and aluminum. Admittedly I have no experience with metal shaping on rollers and wheels and hope to learn from this site. Regards, G. Cross www.crosstravel.us
__________________
Gerald C. Powermax 45, SP-100 on gas, 175 AC/DC Sq Wave, 7" x 12" Band, 16" - 16 speed Drill, 3HP 20Gal Air, 9" disk - 6 x 48 Belt, Sears 8" Pedistal, Victor O/A Torch, 150amp service to the 40'x64' Pole Barn - Priceless 
|
|
#3
03-16-2011, 05:03 PM
|
|||
|
|||
|
Hello and welcome to the site, I am sure you will find what you want on here.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
