|
|
|
#1
03-26-2011, 07:07 AM
|
|||
|
|||
Hello from Down Under
Hi, I am Dave from Australia. I am an Industrial Arts Teacher in South Australia which includes teaching Metalwork. I have bumped into this site looking for information to assist me in resurrecting a 1927 International light truck that I have taken possession of. The sheet metal requires all new panels to be built and I wish to do it myself with some assistance from fellow sheet metal workers.
__________________
Dave 
|
|
#2
03-26-2011, 07:41 AM
|
||||
|
||||
|
Dave, welcome to the site and thanks for the introduction.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
03-26-2011, 09:11 AM
|
|||
|
|||
|
Hello Dave, welcome to the site. I also teach but only part time. (At evening classes in metalshaping) There are many ways of forming metal but to me the first step is to learn hwo to brake a panel down into sections that you can manage.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
|
#5
03-26-2011, 11:19 AM
|
||||
|
||||
|
Welcome aboard Dave:
Have you any photos of your truck?
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#6
03-27-2011, 12:58 AM
|
|||
|
|||
|
Welcome Dave! riverland is a very nice place to spend some time.
regards Dave
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
