|
|
|
#1
02-10-2013, 11:28 AM
|
|||
|
|||
Hello
My name is Charlie and I live near Rochester, MN.
I like to make everything myself including not only parts, but also the tools to make the parts. Usually I'm making parts for motorcycles. I've done a tiny bit of sheet metal shaping, but skill wise I'm pretty much a rank beginner. I joined AllMetalShaping to learn about new-to-me tools and methods.
__________________
Charlie ____________ If you can't ride there on two wheels it's not worth going (unless it's winter in Minnesota). 
|
|
#3
02-10-2013, 04:24 PM
|
|||
|
|||
|
Charlie are you comming up to the spring event in Dennison ? That close it would be a sin not to show . Give me a call if you want to stop up and see what is going on in the shop . 507-263-7411
__________________
Dan Pate
|
|
#4
02-10-2013, 05:01 PM
|
|||
|
|||
|
HI Charlie welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#6
02-11-2013, 10:56 PM
|
|||
|
|||
|
Quote:
__________________
Charlie ____________ If you can't ride there on two wheels it's not worth going (unless it's winter in Minnesota).
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
