|
|
|
#1
01-02-2016, 09:14 AM
|
|||
|
|||
New Project
Hi I am Phil. I am thinking of starting a restoration on a 1933 Willys Roadster and was directed to the site when I started looking for info on building custom floor pans. Cars I have worked on in the past usually 60s muscle you can find pans for them anywhere, but not this one. I will take any hints and skill that can be offered. Thanks and Happy New Year
|
|
#2
01-02-2016, 01:48 PM
|
||||
|
||||
|
Hello Phil and welcome to the forum.
Here is one way to make floor pans. www.youtube.com/watch?v=HTDyE9on4ec Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
01-02-2016, 06:13 PM
|
|||
|
|||
|
Hi Phil welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
