|
|
|
#1
09-05-2012, 09:22 PM
|
|||
|
|||
Raceshop Fabricator
Hi, I have been building modified race cars for the last 40 yrs. Was into hotrods prior to that. In the process of this I never had the chance to learn much of the advanced processes in metal shaping, french wheel, power hammbers etc. Hope to be able to build some equipment to learn these skills. Thanks Curt
__________________
Curt Chase 
|
|
#3
09-06-2012, 01:26 AM
|
|||
|
|||
|
HI Curt welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
09-06-2012, 05:44 AM
|
|||
|
|||
|
I built, owned and entered NASCAR Winston Cup Stock cars for 24 years. You will be amazed at what the gentlemen on this forum can teach you.
Good luck!
__________________
Will
|
|
#5
09-06-2012, 11:29 AM
|
|||
|
|||
|
Welcome Curt. I am in the same boat you are in. I have done a little hammer forming for rear tubs on drag cars and a few dash pieces. Starting to pull away from the Race Car market and get in to metal working.
__________________
Russell N Owner of Racetech Motorsports
|
|
#6
09-06-2012, 05:03 PM
|
|||
|
|||
|
Hi Curt, welcome to almetalshaping.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
