new to sheet metal shaping

[yisalap]

Hi my name is victor, I am from Cantley QC. I have started to have an interest in shaping sheet metal after purchasing a 57 chevrolet to restore. I happen to stumble upon this forum and hope it might add some insight into new ways of shaping sheet metal, what tools others use, and maybe give some ideas of possible future frojects.

[longyard]

Originally Posted by yisalap

Hi my name is victor, I am from Cantley QC. I have started to have an interest in shaping sheet metal after purchasing a 57 chevrolet to restore. I happen to stumble upon this forum and hope it might add some insight into new ways of shaping sheet metal, what tools others use, and maybe give some ideas of possible future frojects.

Bienvenue, mon ami.

[HEATNBEAT]

Hi Victor and welcome!

[Peter Tommasini]

HI Victor welcome to the forum
Peter

[David Gardiner]

Hello Victor, welcome to allmeatalshaping!

David

[yisalap]

thanks for the welcomes,
From what little I have gone through so far of this forum it looks like i'll have several tecniques to try and master to get the shapes I want. now i'ts just to find a relatively easy piece to start with and work my way towards the more complex ones i know I want to make.