All MetalShaping

Go Back   All MetalShaping > Metal Shaping Projects > Automotive Projects
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 10-06-2014, 06:14 PM
Gojeep's Avatar
Gojeep Gojeep is offline
MetalShaper of the Month March 2015, March 2020,, June 2022,Aug 2023
 
Join Date: Nov 2013
Location: Eastern Melbourne, Australia
Posts: 2,986
Default


Time to start on my first cross member. I must have at least two originals for it to be registered as a 48 Willys under club registration rules, in case I go that way for a 90 days a year permit. For full road registration I still require at least one.


Looking a bit worse for wear with rust, twists, bends, dents, holes and buckles!


The old PTO hole was a bit big to just fill with weld so dropped in a washer of the same thickness as the frame.


The copper spoon also works well on edges that need to be repaired.


A lot faster and less heat this way.


Well 40 odd holes filled and a lot of tacks on some rust pitting that was first cleaned out with my die grinder.


Both ends were twisted 5 degrees in the same direction. Most likely the centre section, where the tow hitch was welded on, was bent up after dropping onto a rock ledge.


Just bolted on the old rear cross member from the other frame to lever down on the ends while the press holds the centre steady.


All the twist gone.


As you can see the ends taper up to the same height as the end of the frame rails. Problem is that I am running the rear of the frame 6.5" narrower to match the width of the frame under the Grand Cherokee and all the axle bracket positions. These trucks have a 6.5" wider rear axle than the front and I will be running the same width front and rear.


After cutting to the new length, the ends no longer match the ends of the frame rails. So a wedge was cut out and the flange bent up to match it.


I will box this member as will be used to support a towbar as well.
__________________
Marcus
aka. Gojeep
Victoria, Australia
http://willyshotrod.com

Invention is a combination of brains and materials.
The more brains you use, the less materials you need.

Last edited by Gojeep; 08-01-2017 at 01:56 AM.
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 07:22 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.