All MetalShaping

Go Back   All MetalShaping > GETTING STARTED > Introductions
  Today's Posts Posts for Last 7 Days Posts for Last 14 Days  

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 05-14-2019, 04:03 PM
artfactory artfactory is offline
Member
 
Join Date: Apr 2019
Location: Willits CA
Posts: 2
Question P9 tooling

Good day,

I have recently acquired a pullmax P9. It was set up as a nibbler with a tracing table. I am interested in finding the tracing table a good home and am looking for a centered lower tool holder with a 25mm collet. I also am going to need the collet and nut for the upper to minimally begin the forming operations I purchased it for. Any ideas as to where to look for the holders. Trick tools no longer carries any of the components for the P9. Any help would be appreciated.
Thanks,

Stu
__________________
As always,

Stu
Reply With Quote
  #2  
Old 05-22-2019, 03:42 AM
metal manny metal manny is offline
Member
 
Join Date: Aug 2011
Location: Johannesburg, South Africa
Posts: 417
Default

Pullmax adaptor.pdfHi Stu.
Not certain how your P9 tool post is configured, but on the P-21 model, the tool holder can be inserted with the offset inside or outside the throat. Using this ability, I have fabricated a spacer plate to centre the offset tool holder.
Bearing in mind that original accessories for these machines cost an arm and a leg at best, with this method (if possible in your case) you'll have the best of both worlds!
The attached pic illustrates the principle...
__________________
Manny

Remember that the best of men, are only men at best.

Last edited by route56wingnut; 05-22-2019 at 04:39 AM.
Reply With Quote
  #3  
Old 05-22-2019, 08:41 AM
Ewing Ewing is offline
Member
 
Join Date: Nov 2018
Location: SW WA
Posts: 15
Default

I PM'd you regarding the Pullmax parts you are looking for. I have a few original Pullmax parts for P5 thru P9, including collets w/nuts, lower tool holders, tooling, etc.

Let me know if you have any interest in what I have and we can discuss it further.
Thanks.
Reply With Quote
  #4  
Old 05-22-2019, 05:45 PM
Peter Tommasini Peter Tommasini is offline
MetalShaper of the Month May 2013, Dec 2013
 
Join Date: Apr 2011
Location: Melbourne,Victoria, Australia
Posts: 7,733
Default

Hi Stu welcome to the forum
Peter
__________________
P.Tommasini

Metalshaping tools and dvds
www.handbuilt.net.au

Metalshaping clip on youtube
http://www.youtube.com/watch?v=WEAh91hodPg

Making Monaro Quarter panel:
http://www.youtube.com/watch?v=KIpOhz0uGRM
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:08 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.