#11
|
|||
|
|||
Steven. Drive nails into the table in the required size according to the shape of the spring and bend the appropriate wire.
You can make that easily. In a similar way, I bent iron rods into concrete. This is similar. Just different material. Or use full padding for the entire seat.
__________________
Jaroslav |
#12
|
|||
|
|||
We threaded 3/8" bolts into the top of my workbench, and formed the around them. The workbench top is MDF, so is sacrificial. It will be replaced someday.
__________________
~Steven |
#13
|
|||
|
|||
Steven, Good solution.
__________________
Jaroslav |
#14
|
|||
|
|||
Thanks! I give my younger brother credit for coming up with it before I did.
__________________
~Steven |
#15
|
|||
|
|||
Good idea with the nails/screws, I will keep it in mind!
Antoine
__________________
Antoine Puygranier Resurrecting a 60 ghia: http://www.allmetalshaping.com/showthread.php?t=18852 Fixing a 914: https://allmetalshaping.com/showthread.php?t=20624 |
Thread Tools | Search this Thread |
Display Modes | |
|
|