My first complete car body.

[dwmh]

Looks to fit perfectly. Bravo.

[Jaroslav]

Thank you guys. I'm sending another photo. The parts on the rear right side are already screwed on. I folded them over myself, marked them, cut them and screwed them on for welding. It was a bit of shape tuning, but panel has minimal tension.

[Jaroslav]

I managed to finish the front part. For the last bend, I made a metal gauge to draw a line.

[Gojeep]

You are flying along there mate.

[metalmarks]

Amazing! You will be finished with it next week!

[Jaroslav]

Thank you guys. I think it will be done with the preparation in 3 weeks. As our ancestors did in 1930.
I still have to make fenders and mounting on the chassis.
The race starts on August 11, 2021. I wrote 2022 on the poster. The investor laughed. I'll be done. The others are already on it. Maybe it will go without paint. ??

[Charlie Myres]

Very impressive work Jaroslav!

Cheers Charlie

[Jaroslav]

Thanks Carlie. Straightening the shape and production of the rear part. I used EW in to hand to shape some parts.
I shaped the back from paper. The hole is good for sticking tape. After cutting the paper, a cutting plan is created and shows the places for shaping. I started shaping one part.

[Antoine_P]

Impressive work, congratulations and Thanks for sharing!!

Antoine

[Mike Whelan]

Hi Jaroslav,
I like the handheld tool that you constructed for bending the edge of the aluminium sheet. I'd like to make one!

I would appreciate a photo of the tool. Unfortunately the sheet aluminium has blocked the front of the tool.

Thanks,

Mike