sheet metal challenge - All MetalShaping

08-27-2020, 05:22 AM

fisa

Member

Join Date: Aug 2020

Location: Karachi, Pakistan

Posts: 1

sheet metal challenge

i am asif iqbal recently work on motercycle fender die development ..and stuck at hemming process of edge around the fender .looking solution ,advice or expert opinion.

regards

asif

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 05:42 PM.