|
|
|
#1
03-12-2015, 10:14 AM
|
|||
|
|||
Another from Minnesota
Hello, I'm Larry Schmidt from SE Minnesota. Recently escaped from the high stress Corporate America working as an engineer life to start up a classic car restoration shop. I've been building/rebuilding/fabricating cars both professionally through schooling and personally post grad. Finally made the decision to follow my passion for car restoration/fabrication and need to quickly ramp up my skills for making patch panels that are NLA.
Looking forward to all the discussions.
__________________
Larry Schmidt ISS Werks Classic Car Restorations 
|
|
#2
03-12-2015, 05:08 PM
|
|||
|
|||
Hi Larry welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#3
03-12-2015, 06:18 PM
|
|||
|
|||
|
Welcome Larry , I am up in Dennison and will be hosting an event in May . Stop on up anytime if you just give me a call .
Dan 507-263-7411
__________________
Dan Pate
|
|
#4
03-13-2015, 08:22 AM
|
|||
|
|||
|
Welcome! I will be moving to S.E. MN in two months. Right by the Millville dirt bike tracks. Classic Car Restorations is in Blaine, I'm assuming that's not where you are located?
__________________
Beau Layman from Minneapolis My build thread. http://www.jalopyjournal.com/forum/s...667069&page=22
|
 |
|
|
Linear Mode
