Intro from Australia -

[Gareth]

Hi everyone,

My name is Gareth, and I've just taken on my second vintage car restoration project. This one is a 1934 Plymouth, and is in need of some fabrication to repair the right-hand rear corner.

The car was in an accident in the 60's, and has been in dry storage ever since. The bad section has been cut out, so I'll need to fabricate the corner from scratch. I'm very experienced with Mechanical repair, but Metal Fab will be fairly new to me. Looking to join the forum for tips and techniques.

Anyway, wish me luck.

Cheers,

Gareth

[Peter Tommasini]

Hi Gareth welcome to the forum, where about in Melbourne?
Peter