|
|
|
#1
08-29-2015, 06:47 PM
|
|||
|
|||
An Oregonian living in California.
Hello,
I go by Kyle. I have been a Aircraft sheet metal worker for the past 12 years. I am currently changing careers and moving over to the machining and welding side of aircraft maintenance. I have my airframe license and am working on getting my powerplant license. I have also been an automotive mechanic and fabricator for many years. I perform a good amount of sheet metal repairs on older vehicles. My personal project is a 1973 Plymouth Duster that I made into a demon clone. I have installed new quarters and a taillight panel. I made my own tubs, trunk floor, 4 link, shortened 8.8 rearend. The car also has the a/c, engine, transmission, steering column, fuel system, instrument cluster, and electrical system from a 1994 2wd dodge ram. I have a few degrees and i am almost finished with my bachelors in business. I also recently purchased a 1960's arco gas station on a half acre. I plan on opening my own metal fabrication business. 
|
|
#3
08-30-2015, 07:33 AM
|
|||
|
|||
|
Hi Kyle welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
08-31-2015, 01:31 PM
|
||||
|
||||
|
Hello Kyle and welcome to the site.
Odd to have two new members from California. Stop by if you are up around Willits. Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
