|
|
|
|
|
#1
09-21-2015, 04:14 PM
|
||||
|
||||
Hi Dan, welcome to the forum, post up some photos so we can see what your at. No pressure.
__________________
Tom Poulter Follow the Dream - Sideways -  - But don't fall-off the edge'good to know you guys care' https://ctrestorations.com/ 
|
|
#2
09-22-2015, 01:03 AM
|
|||
|
|||
|
Hi and welcome Dan. I recently built a motorised bead roller from some Tom Verity plans. I was able to do all of the machining in house, but quite a bit of it can be done without access to a mill if need be. There is a build thread here.
http://allmetalshaping.com/showthread.php?t=12894 So far I'm very pleased with it, but I'm pretty new to this. Lots of other simpler builds on here too.
__________________
Richard "I know nothing. I from Barcelona" (Manuel - Fawlty Towers) Link to our racecar project https://www.facebook.com/pages/Elan-...ab=public&view
|
 |
|
|
Hybrid Mode
