|
|
|
#1
10-04-2015, 07:19 PM
|
|||
|
|||
Newbie from Ohio
I'm just getting back into fabrication and metal shaping as I finally have a place to work again with the purchase of a garage that should close by the end of the week. I spent my teenage years working on cars and about anything else. In fact, I still have the 1967 Firebird that I purchased when I was 19.
Unfortunately, time hasn't been good to the 67 bird and I need to do some major work to it. My first task on the car will be to build a chassis jig to support the car as I cut it up and put it back together. I will actually be building two jigs as I have a 68 Firebird that needs much less work. Oh, and the kids need a go cart, so I'll need to fabricate that on a small chassis jig. In general, I'm interest in just making things. I've got some ideas for everything from furniture to a robotic lawn mower. So, I'm here to learn and hopefully help someone out. At least, maybe someone can get a laugh at something stupid I do.
__________________
Ezekiel 
|
|
#2
10-05-2015, 11:17 AM
|
||||
|
||||
|
Hello Ezekieland welcome to the forum.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
10-06-2015, 12:55 PM
|
||||
|
||||
|
Welcome! Great to have another person from Ohio. Soon we might have enough for our own meet.
__________________
Jacob Hunsinger Shrinking using a stump: https://www.youtube.com/watch?v=-HAFndATFo4&t=7s Making a reverse using a stump: https://www.youtube.com/watch?v=7PlF1BoMCQI Circular Truss E-Wheel http://allmetalshaping.com/showthread.php?t=15419
|
 |
|
|
Linear Mode
