|
|
|
#1
10-07-2015, 02:28 PM
|
|||
|
|||
Fng
Hello all,
My name is Lew and I live in Phoenix, AZ. I just purchased a 1948 Chevy Aerosedan and while searching the web on sheet metal repair I came across this site. Immediately knew I had to join to learn from some amazingly talented individuals. Hope to get to know some of you. I know I will undoubtedly learn from this site. Excited to get started. I'll try and post some pics of my car when it arrives...still in rural VA. Cheers, Lew 
|
|
#2
10-07-2015, 07:46 PM
|
||||
|
||||
|
Hello Lew and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
10-08-2015, 08:59 PM
|
|||
|
|||
|
Hi Lew welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
