|
|
|
#1
03-22-2016, 02:30 AM
|
|||
|
|||
New Member
Hello to all.
I have just joined to further my knowledge in metal shaping. I live in Bathurst Australia and over the years restored a few cars but always out sourced the panel work to others. I thought it was time to pull the finger out and have a go. So here I am and look forward to further my understanding in metal shaping Cheers Signed Sam 
|
|
#2
03-22-2016, 12:41 PM
|
||||
|
||||
|
Hello Sam and welcome.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
|
#3
03-22-2016, 06:45 PM
|
|||
|
|||
|
Hi Sam welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
