|
|
|
#1
04-29-2016, 01:36 AM
|
|||
|
|||
New member (also) from Portland Oregon
Hey everyone,
Just came across the site while doing research for a pneumatic planishing hammer I'm drafting / planning to build in June. I live in Portland Oregon and work as an animator. I've been focusing completely on metalworking for about a year now. My areas of interest run a pretty full spectrum at the moment. I was doing some custom body stuff on a 62 Mercury I had, but had to sell because of a move. Now that Im settled again Im devoted 100% to the craft. On top of actual shaping, Im also trying to collect and restore older machines and tools. Something about learning all about the different restoration techniques, and coming out with an amazing piece of equipment. (Most recent find was a Lennox No. 18 throatless shear.) Well, theres my introduction  See you all around!
__________________
Travis F. 
|
|
#2
04-29-2016, 05:49 AM
|
|||
|
|||
|
Welcome to the forum Travis, nice to have you here. Visit often and post when you can.
__________________
Will
|
|
#3
04-30-2016, 04:10 AM
|
|||
|
|||
|
Hi Travis welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
05-12-2016, 11:06 AM
|
||||
|
||||
|
Hello Travis and welcome to the site.
Jere
__________________
Jere Kirkpatrick Valley Forge & Welding HEN-ROB Torch Dealer.  Teaching The Fundamentals of Metal Shaping www.jerekirkpatrick.com All tools are a hammer except the chisel.....That's a screwdriver.
|
 |
|
|
Linear Mode
