|
|
|
#1
02-16-2019, 12:46 PM
|
|||
|
|||
Another newbie from UK
Good evening fellow fabricators. Love bashing metal - especially for old cars and custom tools. Got a few hand tools and some power ones too - sheet metal shears, folder flanger, mill, lathe, MIG, AC TIG, small plasma cutter etc ... all the usual. Used to import Detroit Iron to the UK (before I retired) and did a lot of fettling on the same. So that's hard to give up!!
Like learning new skills - especially for old(er) cars. Used to have four Lincolns from the 80's and 90's (2 Continentals and 2 LSC Marks). Now down to a couple of 20ish year old Rover 75s (a saloon and Tourer V6s). Currently restoring a rear subframe/suspension assembly and making some improvements as I go. Wanted to expand my sheet metal shaping skills so was looking for DIY build plans for a deep throat flanger/bead roller when I happened on this most interesting place. Hope to learn a little and maybe share a bit too? Happy days. 
__________________
Paul S Strudwick 
|
|
#2
02-16-2019, 02:38 PM
|
|||
|
|||
|
Welcome to the forum, Paul
|
|
#3
02-16-2019, 05:24 PM
|
|||
|
|||
|
Welcome to the forum, Paul.
__________________
AC Button II http://CarolinaSculptureStudio.com https://www.youtube.com/channel/UCzSYaYdis55gE-vqifzjA6A Carolina Sculpture Studio Channel
|
|
#4
02-16-2019, 06:43 PM
|
|||
|
|||
|
Hi Paul welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
