Another Rodder from San Diego...

Kerry Pinkerton · #1 06-15-2009, 06:10 PM

Quote:

Originally Posted by Bengels

Thanks Chris,
I had better get a better feel for what you guys are doing here before I start posting up stuff. Cheers!

Welcome Bob, As long as you're talking about projects with a large percentage of metalshaping content, you'll fit right in. I LOVE the COE also!!!

Shobra · #2 06-15-2009, 10:56 PM

Welcome!! That's funny the COE was also the first one to caught my attention.

I see the chop, but is it sectioned too?

#3 06-16-2009, 10:57 AM

3.5" chop, 12"channel, on a Trans Am front clip and suspension. I used the Pontiac 400 motor, Transmission, drive shaft and rearend making it the exact same wheel base as a trans am. The motor and tranny will be replaced with a diesel.

fordguyfordman · #4 07-03-2009, 03:16 PM

That's a killer looking shop truck