|
|
|
#1
04-21-2011, 06:56 AM
|
|||
|
|||
New member
Hi All,
Here's my introduction. name is Mark Emig, I am a 45 year old artist blacksmith from Hurley, New York. I do everything from fancy forged interior/exterior ironwork to plain old fabrication (in this economy a guy's gotta eat). I am looking at building an English wheel for a new toy, er I mean tool and found the site while looking for info. Cheers, Mark Emig 
|
|
#2
04-21-2011, 09:25 AM
|
||||
|
||||
|
Mark, welcome to the site. If you want to learn about cold shaping sheet metal this is the right place. There is also information on the tools that are used to shape sheet metal. Hope you enjoy the site.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
 |
|
|
Linear Mode
