|
|
|
#1
11-22-2011, 05:10 PM
|
|||
|
|||
Hi - Young Gun from AUS
hi everyone, Casper here. 25 yrs young.
i was on google reading about gene winfield and a few forums came up. as a guest i found ur forum to be full of great info so figured i'd better register. my dad is a panel beater/fabricator/boiler maker, no qualifications but went to panel beating school when he was 48yrs of age to learn what he loved. i'm learning from him and my own mistakes and hope to be able to produce some fine skills over the years ahead. currently i'm slowly fixing up rust and dents in my 60 series toyota landcruiser. i seem to be getting more dents and more rust than i can remove :-) good practice anyway. i'm looking at purchasing a 1970 something ford fairlane to do up as a wedding vehicle (recently engaged - Good excuse don't u think?) thanks for a great forum, looking forward to soaking up all the info out there.
__________________
Casper, aka: BILKO 
|
|
#2
11-22-2011, 06:18 PM
|
|||
|
|||
|
Welcome to the site Casper
 Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#4
11-22-2011, 11:20 PM
|
|||
|
|||
|
Hi Casper, welcome aboard.
Where in oz are you? Cheers
__________________
Adam. Assumption is the Mother of all Sutff ups. Resto Rod Race.
|
 |
|
|
Linear Mode
