|
|
|
#1
06-02-2012, 11:05 PM
|
|||
|
|||
Newbie from Carman MB
Hi all. I am a retired tree nursery worker. Have built and repaired equipment and vehicles for most of my life. I enjoy flying RC aircraft and wood working. Currently restoring a 59 Chev Fleetside that is badly rusted. I find the work on this a real learning experience on metal shaping. Hope to gain more knowledge from you folks who are far more experienced than I.
Eric 
|
|
#2
06-03-2012, 09:29 AM
|
||||
|
||||
|
Eric, welcome and thanks for the introduction. Hope you enjoy the site and find it helpful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#4
06-03-2012, 01:50 PM
|
|||
|
|||
|
Hello Eric, welcome to allmetalshaping, I am sure you will find lots to interest you here.
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
