|
|
|
#1
10-09-2012, 07:17 PM
|
|||
|
|||
New Wisconsinite/Iowan Here...
Hey All,
The name is Jeff and I am currently a college student at the University of Iowa but was raised in Milwaukee, Wisconsin area. I have a burning desire to ride stand-up jet skis, and have done extensive fiberglassing work in the past. The main reason I have sought out this sight is because I want to better understand the sheet-metal molding processes. I actually want to see if I can form 1/8" aluminum into a two-stroke exhaust-like shape using cheaper materials than milled steel and a press... I would also like to expand my knowledge in the sheet-metal forming industry altogether. Thanks for your time, -Jeff
__________________
Jeff Grignon 
|
|
#2
10-09-2012, 11:32 PM
|
||||
|
||||
|
Jeff, welcome and thanks for the introduction. Hope you find the site helpful and enjoyable. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
10-10-2012, 12:19 AM
|
|||
|
|||
|
HI Jeff welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
 |
|
|
Linear Mode
