|
|
|
#1
10-29-2012, 09:00 PM
|
|||
|
|||
I think this is my intro
To make a long story short, I ran across this address in the GMC forum and wanted to take a look. I am 72 years old and have been a welder/steel fabricator forever. Or at least it seems like it. Started back in the '60s at the ship yards here in Tacoma Washington I have had the pleasure of pulling one inch shell plate up in the bow of a Coast Guard cutter with 6 3-ton come-a-longs. Me and a little Korean welder. Boy, that was a "time long ago in a galaxy far away". So you see it fascinates me what you guys are doing with 22 ga. Thanks for letting me look over your shoulder...........Terry
__________________
Terry 
|
|
#2
10-29-2012, 09:18 PM
|
||||
|
||||
|
Terry, welcome and thanks for the introduction. Hope you enjoy the site and find it useful. Thanks for joining us.
__________________
Joe Hartson There is more than one way to go to town and they are all correct.
|
|
#3
10-29-2012, 10:33 PM
|
|||
|
|||
|
HI Terry welcome to the forum
Peter
__________________
P.Tommasini Metalshaping tools and dvds www.handbuilt.net.au Metalshaping clip on youtube http://www.youtube.com/watch?v=WEAh91hodPg Making Monaro Quarter panel: http://www.youtube.com/watch?v=KIpOhz0uGRM
|
|
#5
10-30-2012, 08:15 AM
|
|||
|
|||
|
Hello Terry, welcome to the forum!
David
__________________
Metalshaping DVD. www.metalshapingzone.com Metalshaping with hand tools on youtube http://www.youtube.com/watch?v=IGElSHzm0q8 All things are possible.
|
 |
|
|
Linear Mode
